[Kenwood] TS-940 SSB Slope low cut filter inop

[Clif Holland]

Sure. When you tilted over the front panel did you remove screws from the 
panel itself or the chassis furthur back. If from the panel itself when you 
tilted it the corner of the panel mount turned up and broke the slope tune 
circuit board. You need to CORRECTLY tilt the front panel over and remove 
the Slope Tune pot and board and then repair it.

Clif Holland KA5IPF
www.avvid.com




----- Original Message ----- 
From: "Kevin Whitcomb" <kevinwhitcomb at hotmail.com>
To: <kenwood at mailman.qth.net>
Sent: Tuesday, November 13, 2012 9:17 AM
Subject: [Kenwood] TS-940 SSB Slope low cut filter inop


>
> So today I very carefully (I thought) switched out the 2 bulbs in the sub 
> display and I somehow managed to render the low cut side of the SSB slope 
> tune inoperative. The high cut works just fine.
>
> I don't see anything obvious and I wiggled the wires and made sure all the 
> connectors were pressed firm into their housings. Does anyone have any 
> ideas?
>
> Thanks!
> Kevin KD0RUR
> ______________________________________________________________
> Kenwood mailing list
> Home: http://mailman.qth.net/mailman/listinfo/kenwood
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Kenwood at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html