[Kenwood] Kenwood Dual Bander, 2 m HT, microphones, and much more FS

[Ken Simpson, W8EK]

Kenwood Items For Sale

Dual Band FM transceiver, Two meter FM HT, speakers,
chargers and other HT accessories, desk and hand
microphones, cable for switching linear amp, original
Kenwood manuals, etc.:


Kenwood TM-V7 Dual Band FM Transceiver:

The TM-V7 FM dual-band (2 m/70 cm) transceiver is like no
other. And there's a lot inside -- like the "four-in-one"
programmable memory, DTSS and pager functions, 280 memory
channels, plus the ability to receive two frequencies on
the same band, as well as dual band.

Features:
"Four-in-one" programmable memory
Dual receive on same band (f2)
Up to 280 multi-function memory channels
Memory Name function
Multi-scan functions
Visual scan function
DTSS
Built-in CTCSS encoder/decoder
Auto simplex checker
Advanced Intercept Point
6-pin mini DIN connector for 1200/9600 bps packet
Heavy-duty construction
50W/10W/5W on 2 meters
35W/10W/5W on 440 MHz

This unit works 100% and looks very nice.
Radio, Power cord, mic, and paper work included for
$225.


Linear Amp Switching Cable for Kenwood Rigs:

This cable goes from a Kenwood transceiver to a
linear amplifier to switch the amp from transmit
to receive.

One end has a DIN connector, as is used with most
Kenwood rigs. The other end has an RCA phono plug,
as used by most linear amplifiers.

Before using this cable, please check the switching
capabilities of your transceiver.

This cable has one coax for switching the relay. $15


Kenwood TH-235 Two Meter FM HT:

The Kenwood TH-235A Two meter HT has a large easy-to-read
LCD, 60 channel memories with scanning and ten DTMF
memories. Extended receive is 136-174 MHz so it includes
the weather frequencies. When used on external DC power
you will get a full 5 watts output. With the included
PB36 battery pack, it produces 1.5 watts. The low power
setting is 0.5 watts.

Features
Backlit LCD Display
60 Memories
Scanning
Battery Saver
Built-In CTCSS Encode
Extended Receive

This particular unit works 100% and looks like it just came
out of the box new. It came from a silent key who I don't
think ever used it. This one includes the desk charger,
rubber duck antenna, belt clip, and paper work for $110.
I added a new PB-36 battery, as the old one had been in
the drawer long enough that it is not in good condition.

Cigarette lighter power cord for TH-235 above. $12


Communications Speakers:

All have 3.5 mm (1/8 inch) mono plugs.

Realistic 21-549 A
This one is about 4 inches square but only about 2 inches
deep. It is rated for 5 watts, has an 8 ohm impedance, and
is listed as a 300 to 3000 Hz frequency response, making it
ideal for communications. It is black in color, looks great,
and sounds great. $18


Accessories for the Kenwood TH-21 / 31 / 41 series HTs:

Special Antenna adapter that fits the TH-21 series HTs,
and has a BNC on the other end. $10

Kenwood SC-8 T "Soft Case" for any of the TH-21 series HTs
great condition $12

Original Operating manual for TH-21 HT for 2 meters $8

MFJ 287 Speaker Microphone
This was used on a Kenwood TH-225 HT, but it also fits the
TH-21/31/41 series HTs, TH-205, TH-215, TH-415, as well as
others. It has a 3 conductor 3.5 mm plug and a 2 conductor
2.5 mm plug. It works fine. $15

Kenwood W09-0315 charger
This charger is used to charge the larger PB-21 H batteries
for the TH-21 series, and also on other Kenwood radios.
It has a standard 2.1 mm coaxial connector. $12


Accessories for Kenwood TH-205, TH-215, TH-225, TH-415,
and other HTs in this series:

MFJ 287 Speaker Microphone
This was used on a Kenwood TH-225 HT, but it also fits the
TH-21/31/41 series HTs, TH-205, TH-215, TH-415, as well as
others. It works fine, and looks close to new. $15

Kenwood Wrist Strap for TH-215, plus many other HTs. $4

Original Kenwood Rubber Duck antenna from TH-215. $10

BNC to PL-259 antenna adapter
Antenna adapter to fit the BNC connector on the HT and provide
an SO-239 connector that will permit a PL-259 to be attached.
This adapter can be used on any HT with a BNC connector. $5


Deluxe Desk Microphone w/ Kenwood 8 pin connector:

This is a great looking and great performing low impedance
desk mic. It has a quality Shure 600 ohm cartridge in it
(the cartridge alone is over $40 new), with a very nice
black die case base and neck, with a chrome grill. It
looks somewhat like a Shure 444, but no plastic on this
one -- all metal!

This one looks like new, and works the same. It has a
long (approx 6 foot) cord, with a round 8 pin connector
for Kenwood. $75


Kenwood Hand Microphone with round 8 pin plug:

This hand mic works great on most Kenwood rigs with the
round 8 pin connector, such as the TS-430, TS-440, TS-570,
TM-241, TM-2530, TW-4000, and others.
It only says "Electret Condenser Mic" on it, with no
model number.

Basically, this mic is like an MC-43, only with a couple
more features. Of course it has the mic and PTT switch;
it also has up/down switches on the top. There are four
"extra" buttons labeled Call, VFO, MR, and PF. What these
four buttons do depends on the rig that it is attached to.
They will function on some rigs, and are completely useless
on others. There is also a "Lock" switch on the back.

Regardless if you use the four extra buttons or not, you
still have a mic that works like an MC-43.

This mic works fine, and looks like new. I am guessing it
came with a rig, and was immediately put in the drawer. $30


DTMF Touch Tone Microphones:

CES 610 L DTMF Touch Tone Mic
Can manually dial a number, or automatically store it in
the mic, and "speed dial". 12 digit touch tone pad on the
front. 8 pin modular plug (like computer LAN).
Looks to be new. $38

Johnson 250-0761-010 / CES 655 L DTMF Mic
It has a 12 digit pad on the front, and is a rugged mic.
Presently with 4 pin plug.
Looks to be unused. $38


Coaxial Lightning Arrestors:

These lightning arrestors are made to be inserted in to
your coaxial feedline, to help reduce lightning damage.

Cushcraft LAC-1
No markings on this to confirm the model number, but it
looks like the Cushcraft "Blitz Bug".
It has an SO-239 on one end and a PL-259 on the other end
(female UHF on one end and male on the other). $10


Operator's Manual for Kenwood (Trio) TS-440 S:

This is a quality reproduction with a "comb" binding
that has been done by one of the professional reproduction
houses. W7FG I think.

This one has a plastic protector on the front, and is
in very nice condition. It includes schematic diagrams.
$18


Original Manuals for Kenwood equipment:

All manuals are in very nice condition, for Kenwood equipment.
All are original manuals only.

Operating manual for TS-130 S/V HF xcvr $20
Operating manual for TM-2570/2550/2530 2 m xcvr $15
Operating manual for TW-4000 dual bander $15
Service manual for TW-4000 dual bander $20
Operating manual for TW-4100 dual bander $15
Operating manual for TH-21 HT for 2 m $8
Operating manual for TH-225, 2 m HT $12
Operating manual for TH-235, 2 m HT $15
Operating manual for TH-241/441/541 mobile FM transceivers
...For 2 m, 440 MHz, & 1200 MHz. $12
Operating manual for TM-221/421 mobile $15
Operating manual for TR-2400, 2 m HT $12
Service manual for TR-2600, 2 m HT $12
Operating manual for TR-7400, 2 m xcvr $8

Kenwood TM G-707 operating manual in Spanish:
Spanish version of the Operating Manual
for the TM G-707 dual band transceiver. New $10
All other manuals are English.

LF-30A Low Pass Filter $5
MC-30 & MC-35 hand microphones $5
MC-85 desk microphone $4
PB-1, PB-2, PB-3, & PB-4 battery packs $3
PS-6 power supply $6
SMC-24 speaker mic $4
SMC-25 speaker mic $4
SP-430 speaker $2
SP-820 Speaker $2

These are original Kenwood manuals only.


I also have many other accessories available such as many
different types of microphones, HTs, HF, VHF and UHF rigs, HF
and VHF/UHF antennas, and many miscellaneous accessories.
Just too many to list here. Please e-mail your requests.


Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400