[Kenwood] TS-130 Band Switch Alignment

[David C. Hallam]

Delving into my need to jiggle the band switch problem, I find that the 
front band switch wafer is not well aligned with the detent positions of 
the  switch.  As a matter of fact in the 3.5 position, it is just barely 
making contact.  The other two wafers seem to be properly aligned.  Is 
it possible to move the wafer independently of shaft to better align the 
contacts?  Or, do I need to drop the front panel to get to the gear 
assembly to do something?

Further, at the flexible shaft coupling, the flats of the rear portion 
of the shaft going to the amp section are not completely aligned with 
the flats of the front section.  Is this part of a factory final 
alignment or should I correct  this.  I guess this would require 
disassembling the final unit.

-- 
A democratic government is the only one in which those who vote for a tax can escape the obligation to pay it.
Alexis de Tocqueville