[Kenwood] TS-930 YG-455C-1 Filter removal jumper?

[Roger Shultz]

Indeed it does Ken which is the same as on the filter installation
instructions. From what I can tell it is the last two pins of the header
towards the front panel. In that case a standard header shorting jumper like
found on most IDE hard drives will do the job. Just to make sure though, I'm
going to check the wiring as I found in the schematic showing the jumper, so
I think I will be good to go!

73, Roger, NJ2R

-----Original Message-----
From: kenwood-bounces at mailman.qth.net
[mailto:kenwood-bounces at mailman.qth.net] On Behalf Of Grant, Ken
Sent: Thursday, June 23, 2011 12:43 PM
To: kenwood at mailman.qth.net
Subject: Re: [Kenwood] TS-930 YG-455C-1 Filter removal jumper?

Roger, look at page 31 of the owners manual. It shows the jumper to the left
of the filter. Just solder a short piece of wire between the two header pins
to restore to original.

 

73.

 

Ken, VE3FIT


This e-mail may contain confidential and/or privileged information for the
sole use of the intended recipient. 
Any review or distribution by anyone other than the person for whom it was
originally intended is strictly prohibited. 
If you have received this e-mail in error, please contact the sender and
delete all copies. 
Opinions, conclusions or other information contained in this e-mail may not
be that of the organization.
______________________________________________________________
Kenwood mailing list
Home: http://mailman.qth.net/mailman/listinfo/kenwood
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Kenwood at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html