[Kenwood] TS-930 YG-455C-1 Filter removal jumper?

[Dr. David Kirkby]

On 06/23/11 05:43 PM, Grant, Ken wrote:
> Roger, look at page 31 of the owners manual. It shows the jumper to the left
> of the filter. Just solder a short piece of wire between the two header pins
> to restore to original.
>
>
>
> 73.
>
>
>
> Ken, VE3FIT

Yes, I was over complicating thinking there might be an attenuator that needed 
to be replaced. The manual makes it clear one only had to remove a jumper to fit 
the filter, so one would only need to put the jumper back if removing it.

The filter should have an input pin, and output pin and a common (earth) point. 
Just solder a wire so the places where the input and output pins were located 
are just jumpered.

-- 
A: Because it messes up the order in which people normally read text.
Q: Why is top-posting such a bad thing?
A: Top-posting.
Q: What is the most annoying thing in e-mail?