[Kenwood] TS-850S - VS2 VOLUME

[Dan Violette]

Don't have one, but from internet search:

	I also got the VS-2 voice unit.  The voice is the same as the
  older VS-1 for the TS-440, and TS-940, but the unit is in a smaller
  package.  It will speak the frequency in either English or Japanese.
  There is a volume control pot on the bottom of the board which
  should be adjusted PRIOR to screwing down the VS-2.  The output on
  my unit was very low, until I tweaked it up.  Also there are jumpers
  on the board to speed up the voice playback...  You'll need to
  consult the instruction page for the VS-1 for speeds, as there is
  nothing mentioned in the instructions for the VS-2.

I know the DRU-2 required adding a pot to the wires.

/Dan KI6X

-----Original Message-----
From: kenwood-bounces at mailman.qth.net
[mailto:kenwood-bounces at mailman.qth.net] On Behalf Of Jim Vaughan
Sent: Thursday, May 27, 2010 9:56 AM
To: Kenwood List
Subject: [Kenwood] TS-850S - VS2 VOLUME

Does anyone know how to control the volume on the VS-2 Voice Synthesizer on
the TS-850S?

I just installed the VS-2 and it works great, but I can't control the volume
of the VS-2.

Thanks,

Jim, K4TXJ
______________________________________________________________
Kenwood mailing list
Home: http://mailman.qth.net/mailman/listinfo/kenwood
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Kenwood at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html