FW: [Kenwood] RE: Dg-5 Not working. Help needed

[Jim Ricker]

Thanks to Dave, I have been able to determine the problem lies within the
TS-520S itself. If I feed the DG-5 with an external power source it works
great. However as soon as I plug it into the rig it pops the 2 Amp fuse. Any
ideas??

-----Original Message-----
From: kenwood-bounces at mailman.qth.net
[mailto:kenwood-bounces at mailman.qth.net] On Behalf Of Jim Ricker
Sent: Thursday, June 10, 2004 6:30 PM
To: Kenwood at mailman.qth.net
Subject: [Kenwood] RE: Dg-5 Not working. Help needed

Received a nice email from a gentleman named Dave . Looks like the fault is
in the rig :-(:-(:-( Any ideas what to check:

 

 

:Dave, Thanks.... The cord checked good.

I then hooked it up to an external source. IT WORKED. Then tried it back on
the 520 and pop went the fuse. So now I know it's in the rig. Bummer I have
been looking for a DG-5 for years.... Thanks 

>From Dave XXXXXXXXXXXXXXX at XXXXXXXX.XXX

: Thursday, June 10, 2004 5:49 AM

To: Jim Ricker

Subject: Re: [Kenwood] Dg-5 Not working. Help needed

 

Yes, the DG-5

See if you can power it up externally, or check it's 12 volt line for a
short.

...Dave

 

 

  _____  

From: Jim Ricker [mailto:jim7j6cef at yahoo.com] 
Sent: Thursday, June 10, 2004 5:23 AM
To: 'Kenwood at mailman.qth.net'
Subject: Dg-5 Not working. Help needed

 

Hello just got through re arranging the shack. As I leaned over the TS520s
to connect the DG-5 II accidentally powered everything off. hit the power
switch. I did this at the same time I was plugging in the power cord from
the DG-5. I heard a slight click/pop. I then noticed that the rig was on. I
shut everything down.  I then I turned it back on the radio was ok but no
display from the DG5. I then did the following.

 

1.	I replaced the 2AMP fuse on the back off the radio. 
2.	Fired up the radio still nothing from the DG-5
3.	Shut it down and checked the 2 Amp fuse it was blown.
4.	 Again I replaced the 2AMP fuse on the back off the radio.
5.	Fired it up still nothing from the DG5. 
6.	Shut it down and found that again the 2 Amp fuse was blown.
7.	I replaced the 2 amp fuse and removed the power cord from the DG-5 .
8.	Fired up the rig and let it run for 30 minutes.
9.	Shut off the rig and checked the 2 amp fuse it was fine. 
10.	Let everything sit for 24 hours. Plugged back in the DG05 Powered on
the radio.
11.	Nothing from the DG-5, Shut it down and checked the fuse it was
blown

 

 The radio is working great. The Dg-5 was working fine prior to this
incident.

 

Any ideas??   Thanks Jim

 

 

_______________________________________________
Kenwood mailing list
Kenwood at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/kenwood
Help: http://mailman.qth.net/subscribers.htm