[Kenwood] TS-850 "Fine" Tuning?

Thu, 30 Oct 2003 15:15:04 -0800

Yes

I have it now.  Sorry for the confusion!

bob

At 04:11 PM 10/30/2003 -0600, jdraughn wrote:
>Hi Bob,
>The way it should work is that, "Fine" changes the amount of turning it
>takes
>to move the display 1 kKz.
>
>With the "Fine" engaged it should take 1 complete turn of the dial to move 1
>kHz.
>Without "Fine" being engaged it should take 1 turn to move 10 kHz.
>
>Try using the set screw in the tuning knob as a point of reference and set
>the display so it ends in  .00 turn the dial 1 turn and see how much the
>display changes. Then engage the "Fine" control and go one turn again while
>watching the display.
>
>If this is not happening there is a problem.
>
>Hope this helps.
>
>Regards,
>Jeff, N0OST
>
>
>
>-----Original Message-----
>From: [email protected]
>[mailto:[email protected]]On Behalf Of Bob Snelgrove
>Sent: Thursday, October 30, 2003 1:10 AM
>To: [email protected]
>Cc: [email protected]
>Subject: [Kenwood] TS-850 "Fine" Tuning?
>
>
>Hi Guys
>
>I don't think my "fine" function is working. I push the button and hear the
>beep, the "fine" lights up in the display but the VFO doesn't change the
>freq. any slower than when it's not engaged.  Could I have missed something?
>
>thx
>
>bob
>
>
>
>
>- - -
>
>Your moderator for this list is:
>Larry Wilson KE1HZ [email protected]
>
>_______________________________________________
>Kenwood mailing list
>[email protected]
>http://mailman.qth.net/mailman/listinfo/kenwood
>
>
>