[Kenwood] help [TS-570D(G) Hangs up on TX]

Sun, 19 Jan 2003 10:49:33 -0800

RF getting into the mike circuit ia a possibility.  Check to be certain
that the radio and antenna have a good RF ground, as well as a good
electrical ground through the AC power plug.  A "grounding adapter" on
an ungrounded outlet does not qualify, and may be unsafe if the outlet
is not in a well-grounded metal box.

73, Eric Lemmon WB6FLY

McKay wrote:
> 
> I just bought a new TS-570D(G) and have encountered a problem. Using it on
> SSB tonight I noticed that sometimes instead of dropping out of TX
> immediately after I let go of mike button (hand mic) it would hold for maybe
> four seconds and then drop back to RX. It just happens now and then. VOX
> gain and delay are at default settings and VOX is on. Any suggestions?
> 73, Archie, K4GA
> 
> - - -
> 
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
> 
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood