[Kenwood] TS-2000 and packet

Sat, 9 Aug 2003 12:01:36 -0500

Hi Kevin, hard to help long distance but I'll try a few suggestions.
First..make sure you are getting the  (cmd) prompt from the radio..this
tells you the tnc is on and the radio and computer are talking. Next the
command to tx without being connected is (K). If you can't tx by hitting
enter after using this command you do have other problems. Lastly...check
that you have your callsign set using the (mycall) command at the cmd
prompt. Most nodes won't let you connect unless you have that set. Be glad
to help if I can.
73 de Tim  K�FL

*****************************************************************
France has neither winter, nor summer, nor morals.
France is miserable because it is filled with
Frenchmen, and Frenchmen are miserable
because they live in France. - Mark Twain

----- Original Message ----- 
From: "K. McMillan" <[email protected]>
To: <[email protected]>
Sent: Saturday, August 09, 2003 11:41 AM
Subject: [Kenwood] TS-2000 and packet

> I am have problems connecting to packet nodes with the built in TNC on
> my TS-2000.  I get a disconnect status every time.  I followed
> instructions sent by Kenwood Tech Help.  Only once was I able to get the
> radio to TX with packet activated.  However, I cannot duplicate what I
> have done.  Can someone give me some assistance please.  The P.C.T.
> works fine.  What am I doing wrong?
> Kevin
>
> - - -
>
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood