[Kenwood] tuning rate

[Glenn Wiebe]

Al, I don't have a scanner at this moment or I'd send you a copy of the
manual. Here are the instructions.

1. Remove the top and bottom covers from the radio.

2. Remove the countersink screws (2 on each side) that secure the front
panel to the chassis and gently pull the front panel forward.

3. Remove the 5 small round head screws that secure the shield plate (2
on top and 3 on the bottom) to the front panel, and remove the shield
plate.

4. Cut the lead of diode D66 located below the dip switch on the control
unit.

5. Reverse steps 1 - 3 to reassemble the radio.

73 de Glenn...VE4GN

k7iey@netscape.net wrote:
> 
> I have obtained a ts-440s to check out.  Seems to work fine.  No manual yet, but one apparently in storage.  In the meantime, can someone provide me with the procedure for adding the last digit to the tuning?  It reads, for example, 14.050.0 but think there should be an additional digit available after the last zero.  Tried the procedure used on the ts680s but not applicable to the 440S.  Thanks in advance!
> Al K7IEY