[Kenwood] foot switch

Wed, 10 Jul 2002 20:08:29 -0700

The more I think about it the more I think that the DIN is the correct way
to go.  Harder to solder yes, but it puts the foot switch conn. to the rear
of the radio instead of in the front and in the way of everything.

Larry
----- Original Message -----
From: Les Severson <[email protected]>
To: Larry L. Ravlin <[email protected]>
Cc: Kenwood <[email protected]>
Sent: Tuesday, July 09, 2002 6:07 PM
Subject: Re: [Kenwood] foot switch

> Hi Larry,
> First you hire a little girl that works for Kenwood with tiny fingers and
> great
> dexterity to do it for you.  hi
> Then buy a 7 pin din plug..  Available at most parts supply places.
> Solder the center conductor of the shielded line from the foot switch to
pin
> 3 of the plug.  Twist and solder the shield  to a ground tab on the plug.
> This will do it ......and it works very well for cw.   Much better than
> keying with the
> vox circuit.
> If you ever have to add the alc line and relay circuit in this same SMALL
> plug for a linear,  then you will need some swear words to complete the
job.
>
> 73,   Les,  W�OJH
>
>
>
>
> "Larry L. Ravlin" wrote:
>
> > I would like to hook a foot switch up to a TS-830S in the PTT line for
CW
> > operation.  Can someone tell me how it is done?
> >
> > Larry AA7LR
> >
> > - - -
> >
> > Your moderator for this list is:
> > Larry Wilson KE1HZ [email protected]
> >
> > _______________________________________________
> > Kenwood mailing list
> > [email protected]
> > http://mailman.qth.net/mailman/listinfo/kenwood
>
> - - -
>
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood
>