[Kenwood] TS-2000 and MCP Software problem

Sun, 1 Dec 2002 08:51:26 -0000

I set the 2000's menu #56 at 19200bps and the MCP software to match. Click
on con in the program and it should take over.
Steve
N4LQ

----- Original Message -----
From: "NZ8J" <[email protected]>
To: <[email protected]>
Sent: Sunday, December 01, 2002 1:46 AM
Subject: [Kenwood] TS-2000 and MCP Software problem

>     I loaded the free MCP software from Kenwood and have the computer
> connected to the radio, but cannot seem to establish communications with
the
> radio.  I have successfully used the same computer and cable to run a Ten
> Tec Jupiter, so I know the basic setup works. I have checked the ports and
> speed. Is there something that must be set in the radio menu to make it
> work, I can't see anything obvious..
> Thanks
> Tim
> NZ8J
>
>
> - - -
>
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood
>