[Kenwood] Re: Kenwood TM-732e - reset code

[Clif]

TM732 Reset procedure.

Vol/SQ fully counterclockwise
Hold down "MR" and power up, after all segments light up turn off power.
Hold down "F" and "MR" key and power up, hold for appx 4 seconds until all
is set to factory spec.

The battery is not hidden, that is the standard placement for batteries in a
Kenwood VHF/UHF mobile.

Clif Holland, KA5IPF
AVVid IS MOVING, SEE THE WEB-SITE FOR MORE DETAILS
AVVid
Authorized Kenwood and Icom Amateur Service
www.avvid.com
1-800-214-5779


----- Original Message -----
From: "Alan Morris" <landy@computerweekly.net>
To: <kenwood@mailman.qth.net>
Sent: Thursday, August 15, 2002 5:19 PM
Subject: [Kenwood] Re: Kenwood TM-732e - reset code


"fredv" <fredvp@snet.net> wrote:-

> My 732 is still ok after almost 9 years. But I suppose I will need a
battery too someday. Where was it by the way?

Sorry about the long delay in replying Fred.  It's a normal CR 2032 3 volt
Lithium coin cell, as used in Psions as a back-up battery and other small
electronic devices.  But it's the version with two tabs for soldering in.

Waters & Stanton (a UK Ham retailer) charge 3� times the price of the one in
this computer.

It's mounted on the PCB that is placed vertically between the surface of the
removed front panel and the diecast chassis.  It's well hidden below the
plastic that supports the front panel, on the side of the PCB facing the
front.

--
Alan R Morris, G4ENS.
Bury St Edmunds, Suffolk, UK.
Using a Psion 7 & Nokia 6210e

- - -

Your moderator for this list is:
Larry Wilson KE1HZ kenwood-owner@mailman.qth.net

_______________________________________________
Kenwood mailing list
Kenwood@mailman.qth.net
http://mailman.qth.net/mailman/listinfo/kenwood