[Kenwood] TS930 S-Meter adjustments

Fri, 9 Aug 2002 12:47:34 -0000

Hi Joe

Thanks for your response.  I have checked page 63 of my service manual here
and it makes no mention of S-meter adjustment.  In fact, I can find no
reference to it anywhere in this manual. I guess my copy is a different
version to the one you have.  Can you tell me what your manual says about
S-meter set up and what pots are involved please?

Many thanks

73

Bob 5B4AGN, P3F, ZC4ZM

----- Original Message -----
From: "Jose B.da Silva" <[email protected]>
To: "Bob Henderson" <[email protected]>
Sent: Friday, August 09, 2002 12:10 PM
Subject: Re: [Kenwood] TS930 S-Meter adjustments

> According to the service manual that I have, VR2 and VR3 in the signal
unit
> are not for receiver adjustments. They are for TX MIX balance.
> The S meter adjustment procedure is in the page 63.
>
> Joe, PY5CEK
> ----- Original Message -----
> From: Bob Henderson <[email protected]>
> To: <[email protected]>
> Sent: Thursday, August 08, 2002 1:31 PM
> Subject: [Kenwood] TS930 S-Meter adjustments
>
>
> > My TS930S s-meter zero and sensitivity need to be adjusted but I am
darned
> > if I can find which are the appropriate pots to do this.  My handbook
says
> > VR2 is zero and VR3 is sensitivity.  The only board I can see which
seems
> to
> > have VR2 and VR3 is the signal board and the service manual says these
are
> > for something else entirely.
> >
> > Can someone who has done the adjustment point me in the right direction
> > please?
> >
> > Many thanks
> >
> > Bob 5B4AGN, P3F, ZC4ZM
> >
> >
> > - - -
> >
> > Your moderator for this list is:
> > Larry Wilson KE1HZ [email protected]
> >
> > _______________________________________________
> > Kenwood mailing list
> > [email protected]
> > http://mailman.qth.net/mailman/listinfo/kenwood
>
>
>