[K3PZN-List] More Ham Equipment for Sale by K4CGY

[James Owen]

Hi Guys,
   I have a few more items to add to the list. The
VHF/UHF antenna's are now down.

Today's list is as follows.

Cushcraft A503S 6M 3 ele Yagi 8.0 dBi gain $90.00.
This antenna is almost new.

Cushcraft Boomer 13B2 2M 13 ele Yagi 15.8 dBi gain,
26Db FB, 15' boom length. $145.00  Will need new
U-bolt clamps otherwise in excellent condition.  

Cushcraft Twist Oscar Beam, A148-20T 20 ele, 13 dbd
Gain, on 10.8' boom. $125.00  This will need some
steel hardward replaced. Mainly the u-bolts and nuts
mounting the elements, other wise great condition.

Cushcraft Twist Oscar Beam A432-40T 40 Ele, not sure
of gain but likely around 15-17 dbd. $80.00. Will need
all steel hardward replaced, mainly u-bolts and
clamps.

Alliance HD-73 Rotor and control box in good condition
but needing steel mounting bolts replaced. $110.00

Previously listed HF Rigs still available.

Icom IC-746 Pro with optional PS-125 power supply S/N
01598 includes instruction book. This transceiver
covers 160M thru 2meters and is in very good to
excellent condition. It's clean though it has a few
scratches on the case. I have done a quick check and
it seems to preform just fine. I would give it a 9 out
of 10 rating. $1325.00. 

Yaesu FT-726R VHF/UHF/Satellite Transceiver. Rated at
10W output CW/SSB/FM and I measure about 12 watts with
a Bird 43. This has the satellite module so that it
can be operated full duplex. Modules for 2M (144-148
Mhz) and 70cm (430-440 Mhz). There is a blank slot for
an additional module 50 Hmz or 440-450 Mhz. This unit
does not have the optional CTCSS Encode or Decode
module. I'm not sure but it may have the optional Cw
filter. It fairly clean though some dust has filtered
through the louvers in the case but not very much.
There are some scratches and mark on the case and a
plastic clip over the handle is missing. I would give
it a 7.5 of 10 rating. It seems to operate ok though
it has one issue. I'm told that this has been seen for
years. If left off for a week or more it requires
about 20 minutes warm-up before the SSB/CW section
will operate. It indicated about S7 or the S-meter
that slowly drops to S0 at which point the receiver
has full gain. Looks to be something biasing the AGC
line. Doesn't do this on FM. After the warm up it
won't do it again for a few days. I don't consider
this to be a major issue. $395.00.



Realistic HTX-202 2m HT in excellent condition. With
Akaline battery holder and Nickle-Metal Hydride
batterys. Includes instruction book. $55.00

Advanced Receiver Research GaAsFET low noise
preamplifiers. These have a gain of about 24db with a
noise figure under .6Db. Three units SP50VDG, SP144VDG
and SP432VDG  (50 Mhz, 144 Mhz and 432 Mhz). I'm told
these were operating perfectly when last used and have
a pin diode switch to allow in line operation with a
transceiver if power doesn't exceed about 20 watts,
otherwise need to use relay switching. Comes with a
one page installation guidelines. $50.00 each.

Please email me at K4CGY at yahoo.com or call
410-635-2989 after 7PM.



73 Jim K4CGY




James C. Owen, III K4CGY

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com