[K3CAL] Pixie 2 40 meter CW Transceiver Project Kit

[Eric Christensen]

On Monday, February 08, 2016 08:39:00 AM Steve Hempling wrote:
> Hi All!   At the last meeting we talked about building a simple CW
> Transceiver that we could build and use On the Air,
>              to practice CW and make some contacts. The frequency of
> 7.040 was chosen to allow license classes of
>              Technician thru Extra to use.  It is a simple kit with few
> parts and small enough to put into an Altoids tin
>              or smaller enclosure of your choice.  It should be able to
> be built in an evening or two, and uses a PC board
>              as you can see in the two links below...  total cost should
> be less than $10.00 w/o enclosure and I am putting
>              this up here to see how many I will be ordering. To those
> that are interested I would like to see an e-mail from
>              you, off the reflector, to my e-mail address on my cell...
> _n3ipnsteve at gmail.com
> _            I would order the kits and crystals and costs would be my
> cost/how many I order.  Please try and respond
>              within a week or two, as I would like to get them ordered
> so we could build before Spring and allow others to
>              see this post and not miss out!!  I will post again with
> the total to be ordered, so others can get in before I
>              place the order..     Thanks and 73 to all!   Steve N3IPN

Steve, please order me two and, if possible, the crystal for 3.58 MHz 
(https://www.halted.com/commerce/ccp12792-crystal-3-58-mhz-28hc-1829-11697.htm).  I looked for a crystal for 7.114 (in the old  
Novice portion of the band and the "default" QRS calling channel) but I didn't 
find one.

Thanks for taking the lead on this.  I hope others will take advantage of this 
project and we can put these together as a group!

73,
Eric WG3K