[JRC] NRD545 WIDEBAND CONVERTOR

[Bob Spooner]

It sounds like you are in AM mode rather than FM and are slope detecting 
the signal when you tune off frequency. Could that be the problem?

73,
Bob  AD3K

MW1DUJ@aol.com wrote:
> Hi,
>     I have not used my wideband convertor for a while now, and had forgotten 
> about this, one of our local FM radio stations is on 106.0MHz, if I tune the 
> receiver to it, the "S" meter reads almost full scale, not surprising, but 
> there is no audio out, the only way to get it to produce any sounds is to 
> tune slightly above or below the frequency, if it was only up or only down, I 
> would suspect a LO freq. inaccuracy, but thats not it, and it is the same on 
> all local stations, any ideas? Dave
> 
-- 
                             Robert L. Spooner
                      Registered Professional Engineer
                        Associate Research Engineer
                   Intelligent Control Systems Department

          Applied Research Laboratory        Phone: (814) 863-4120
          The Pennsylvania State University  FAX:   (814) 863-7841
          P. O. Box 30
          State College, PA 16804-0030       rls19@psu.edu