[Johnson] Invader 2000 Question

[Al Parker]

Hi David,
	I was into my Inv2000 abt 2 wks ago, had lost HV to the 4-400's.  I'm 
pretty sure you are correct.  The 200 gets it's pwr thru the 125 vac 
plug on one side of the 240v input, b4 those fuses.
	I did get mine on the CX last Sun.
73,

Al, W8UT
www.boatanchors.org
www.hammarlund.info

"There is nothing -- absolutely nothing -- half so much
worth doing as simply messing about in boats"
Ratty, to Mole

On 2/12/2015 10:12 AM, David C. Hallam wrote:
> I have to work on my driver section of the 2000.  I was getting reports
> of distortion on my signal and now I have no output at all from the 200
> section.  Looking at the schematics, it appears  as if I can disable the
> HV by removing the fuses in the HV transformer primary and then remove
> the filament and screen voltages from the 4-400's by unplugging the
> cable that goes the J203.  This will completely disable the amp section
> but  leave power on the 200, leaving me free to work on it.
>
> Am I correct?
>
> David
> KW4DH
>