[Johnson] T-bolt en Valiant

[James M. Walker]

Hi Folks,
I run a Central Electronics 10B w/VFO458 into my T-Bolt, works great on
AM/CW/SSB. And with a properly working 10B I still have to watch that
I don't over drive the T-Bolt. Also I have the original setup as mentioned
elsewhere on this list, got the Pacemaker, and the T-Bolt paired up, and
yes the attenuator is definitely needed there, even with 1 6146 in it you 
must
be careful not to overdrive the T-Bolt. I used for a while the Johnson
attenuator, but found I still needed to cut back, so I built a switchable
one out of 5% 2 watt carbon resistors, I have a schematic, taken from the
old ARRL SSB booklet. I like the Pacemaker for "Cruise-Ability" for
same old frequency stuff The CE 10B workes just fine. As usual YMMV.
Jim
WB2FCN

----- Original Message ----- 
From: "TOWN COUNTRY FLOORS Owner" <quindecima at msn.com>
To: "Johnson" <johnson at mailman.qth.net>
Sent: Monday, February 19, 2007 5:43 PM
Subject: [Johnson] T-bolt en Valiant


> Well, so much for that brainstorm.  Now that it has been explained to me I 
> see the wisdom.  I would go with a Ranger and the t-bolt but I am going to 
> be out of room shortly.  I am hard pressed with my Valiant/NC183D and 
> 32V-1/75A-1 for space although if I moved my wife into the spare 
> room...Hummmmm.
>
> Larry
> Johnson mailing list
> Home: http://mailman.qth.net/mailman/listinfo/johnson
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:Johnson at mailman.qth.net
>
>
>