[ICOM] No power out on my 7600

[JK]

It seems I have heard about quite a few uneplained final failures in 
Icom radios from IC-751 and beyond.


Where U doing anything unusual that could cause final failure?


Check output on all bands. On my 756 Pro lll  recently had close to full 
output on some bands and hardly any on others. Finals had to be 
replaced. My finals were damaged when I was using a beverage antenna 
connected to the ant aux socket. It seems ICOM does not switch off that 
connector when in transmit mode and this allows high voltages or 
currents to get into circuitry that may cause damages to components on 
the PA board.


Good luck. Hope it is not ur finals.


Jay...NE2Q

On Sun, May 22, 2016 at 08:01 AM, Jim Fox wrote:

> My 6 year old 7600 has apparently lost its finals. Worked fine last 6 
> years but last night no power out (10 watts). I'm in the process of 
> moving from Kansas to Arizona so don't have much time to trouble 
> shoot. Have full 13.8 volts at the back of the radio into dummy load. 
> Any quick check ideas ?     Jim / w7hfg
>
> Sent from my iPad
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>