[ICOM] IC746pro or IC-7400 Service Adjustment Mode ??

[Larry Young]

Tim: I believe the short circuited jack inserted into the remote socket is a mono and not a stereo jack, so insure that it is.Turn the radio power off, then insert the jack, and pushing and holding the menu button turn on the radio power. Hopefully it will than go into the adjust mode.Good luck, 
Larry, K4LXV
 


     On Sunday, September 20, 2015 10:02 PM, Tim <timt at skybase.net> wrote:
   

 Hi all,

So I'm working on a 7400 aka 746pro and I'm stepping through the 
adjustment procedures in the service manual and I get to the "Adjustment 
Mode" Section 5-5 of the service manual.

To get into ADJ mode... Terminate the remote socket, hold down MENU & 
SSB while turning the power on.

This isn't working for me even after a CPU reset.

Has anyone seen this ?

Is there some other magic three finger action ?

Do your radio's go into ADJ mode when doing that action ?

Any help appreciated!

thanks

Tim

-- 
VK2XAX :: QF56if23 :: BMARC :: WIA :: AMSATVK

----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html