[ICOM] 756Pro3 tuning knob turns roughly

[JERRY]

look at the main tuning knob. There should be a rubber band around the knob. 
lift
the band  off and tighten the set screw. Worked for me

-----Original Message----- 
From: Joe Stepansky
Sent: Sunday, August 09, 2015 5:48 PM
To: 'ICOM Reflector'
Subject: Re: [ICOM] 756Pro3 tuning knob turns roughly

If there's some sort of brake control, I don't see it.

73, Joe KQ3F

-----Original Message-----
From: Icom [mailto:icom-bounces at mailman.qth.net] On Behalf Of Jerry Flanders
Sent: Sunday, August 09, 2015 5:15 PM
To: ICOM Reflector
Subject: Re: [ICOM] 756Pro3 tuning knob turns roughly

Isn't there a "brake" control for it? Look for a little lever near the knob
that might have gotten moved.

I could be remembering some other radio's feature. Been a few years since I
had a PRO3.

GL

Jerry W4UK

At 05:05 PM 8/9/2015, you wrote:
>I put my 756 Pro3 back in its original box for a few weeks (stored with
>all the cushions intact and the box wasn't moved after packing), and
>when I took it out, discovered the tuning knob turned very stiffly.
>Before sending it back for repair (again), is there anything I can do to
loosen this thing up?
>Thanks!
>
>
>
>73, Joe KQ3F
>
>----
>Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net Icom
>Users Net: Sundays, 1700Z, 14.316 MHz Icom FAQ:
>http://www.qsl.net/icom/ To support QSL/QTH.net:
>http://www.qsl.net/donate.html

----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net Icom Users
Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/ To
support QSL/QTH.net: http://www.qsl.net/donate.html

----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html