[ICOM] ICOM IC-03AT belt clip screw

[QTHnet-icom.K6PDG at OrdinaryAmerican.net]

Thanks, Larry

73
Patrick K6PDG

On Mon, Jun 2, 2014 at 11:00 AM, Larry L. Hinton - hinton.ll at frontier.com
wrote:

> The case screws are M2 x 0.4. If memory servers me, the belt clip screws
> are M4 x 0.7.
>
> As a suggestion, remove the other belt clip screw and use that as the
> model.
>
> As for sizes, as measured at the tip of the threads with a caliper:
>
> M2.5 x 0.45:    2.480 mm
> M3 x 0.50:       2.980 mm
> M3.5 x 0.6:      3.479 mm
> M4 x 0.70:       3.978 mm
>
> The above are "standard or JIS". Course threads are not used with screws
> below M10.
>
> Larry
> K7YBZ
>
>
> ________________________________
>  From: "QTHnet-icom.K6PDG at OrdinaryAmerican.net"
> <QTHnet-icom.K6PDG at OrdinaryAmerican.net>
> To: icom at mailman.qth.net
> Sent: Monday, June 2, 2014 9:45 AM
> Subject: [ICOM] ICOM IC-03AT belt clip screw
>
>
> I've lost one of the screws that holds the belt clip to the HT. Does anyone
> know the size and thread pitch of those screws? The instruction manual only
> shows that there are two of them.
>
> I've already asked ICOM Technical Support. One of them replied he was
> unable to find the information.
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>