[ICOM] ICOM IC-03AT belt clip screw

[Larry L. Hinton]

The case screws are M2 x 0.4. If memory servers me, the belt clip screws are M4 x 0.7.

As a suggestion, remove the other belt clip screw and use that as the model.

As for sizes, as measured at the tip of the threads with a caliper:

M2.5 x 0.45:    2.480 mm
M3 x 0.50:       2.980 mm
M3.5 x 0.6:      3.479 mm
M4 x 0.70:       3.978 mm

The above are "standard or JIS". Course threads are not used with screws below M10.

Larry
K7YBZ
 

________________________________
 From: "QTHnet-icom.K6PDG at OrdinaryAmerican.net" <QTHnet-icom.K6PDG at OrdinaryAmerican.net>
To: icom at mailman.qth.net 
Sent: Monday, June 2, 2014 9:45 AM
Subject: [ICOM] ICOM IC-03AT belt clip screw
  

I've lost one of the screws that holds the belt clip to the HT. Does anyone
know the size and thread pitch of those screws? The instruction manual only
shows that there are two of them.

I've already asked ICOM Technical Support. One of them replied he was
unable to find the information.
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html