[ICOM] pro 3 repair?

Fri Oct 25 17:48:58 EDT 2013

I used this for the repair of my 735 a couple of years ago, and the communications, service, and quick turn around that Scott provided were very good. I suggest giving him a call to see if he can or is willing to look at a Pro 3. 

http://www.angelfire.com/biz2/mts/ 

Regards,

Jim T.
WB8HMD

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On Behalf Of k0bx at arrl.net
Sent: Friday, October 25, 2013 4:33 PM
To: ICOM Reflector
Subject: Re: [ICOM] pro 3 repair?

Whats up Chuck?

Had to say it, I setn my Pro-3 to Icom East the 1st time.  Did a FB Job, 2nd time (out of warranty) I sent it to Burkhart in SD.  They installed a Front-End mode on mine.
Mine had no output on any band but it was not the finals.

Joe K0BX

#1 Honor Roll Mixed
Honor Roll RTTY

Stop the insanity!
Please do not add me to any distribution lists (Joke, Stories or Junk) without my permission.

________________________________
 From: "KI9A at aol.com" <KI9A at aol.com>
To: icom at mailman.qth.net
Sent: Friday, October 25, 2013 9:12 PM
Subject: [ICOM] pro 3 repair?

Gang, my pro3 just popped the PA, intermittent output varies from  around 
90w down to 20w on all bands ( yes, into a 50 ohm load).

Who is the guy to send it to these days? I sent a 746 off about 10 yrs  ago 
for some work, ant remember where though.

73- Chuck KI9A 
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html