[ICOM] Icom IC-2AT, 2 m HT and accessories FS
Ken Simpson, W8EK
kenw8ek at gmail.com
Thu May 2 09:11:44 EDT 2013
Icom IC-2 AT, 2 meter HT and accessories For Sale:
Icom IC-2 AT, 2 meter HT:
The Icom IC-2 AT is a fairly generic HT for the 2 meter band.
It is fully synthesized, with the frequency controlled by thumb
wheel switches on the top; it has a touchtone pad on the front.
For a long time, this was the "standard", since it is such a
well built HT.
The HT has about 3 watts output in high power and just under a
watt in low. Instead of a NiCad pack that would likely be dead
anyhow, this HT has the "empty" battery pack that takes six AA
cells. You can use NiMHs in this, and then recharge the
batteries outside of the pack, or you can use alkaline cells.
Using this type battery pack is the only reasonable way to go.
This particular unit works 100% and looks very, very nice.
Rubber duck and paper work included for $35.
Icom DC-1, 13 V DC adapter for many Icom HTs:
This adapter slides on the HT, in place of the battery pack.
If 13 V DC is applied, it converts the voltage to the proper
voltage for the HT. It can be used with the IC-2, IC-3, IC-4,
IC-02, IC-03, IC-04, and others. This one works fine, and
looks very nice. With paper work for $18.
Icom CP-1 DC cord
This cord will work with the DC-1 above, plus many other items needing
the 2.1 mm coaxial power plug. The opposite end has a cigarette
lighter plug on it. $10
Multi Band BNC Telescoping Antennas:
Two telescoping antennas are available. Both are in very
nice, close to new condition, and have BNC connectors.
ANLI AL-800 dual band HT antenna
This is a telescoping antenna that pulls out to about
a 3 foot length. If covers both 2 meters and 440 MHz,
and has a BNC connector on it. It is rated to have
3.2 dbi gain on 2 meters and 5.6 dbi gain on 440 MHz.
It appears close to new. These are $39 on Amazon.
Get this one for only $25.
Radio Shack 20-006 A
This antenna is just over 2 feet in length when fully
extended. Radio Shack does not give it any gain rating,
and I don't know if I would trust those ratings anyhow.
It is safe to say it performs better than a rubber duck
antenna. This one will cover 6 m, 2 m , 220 MHz and
440 MHz. BNC connector. It is actually in its original
bag with original paper work. $15
MFJ-284 HT Speaker Microphone:
This speaker mic has the 3.5 mm and 2.5 mm plugs on
it, as used by Icom, Alinco, Radio Shack, some Yaesu,
and many other HTs.
It works with the Icom IC-2 AT above, but also with
the following:
YAESU 109, 209, 709, 23, 73, 33, 727 and other YAESU
radios which are pin compatible with the above rigs.
ICOM 2AT, 02AT, 3AT, 03AT, 4AT, 04AT, 12AT, u2A, u2AT,
u4AT and other ICOM radios which are pin compatible
with the above rigs.
ALINCO DJ-560 and other ALINCO radios which are pin
compatible with the DJ-560
RADIO SHACK - most
SANTEC ST-20
It works great, and looks like new.
With paper work for $15.
I also have many other accessories available such as many
different types of microphones, HTs, HF, VHF and UHF rigs, HF
and VHF/UHF antennas, etc.
Just too many to list here. Please e-mail your requests.
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400
More information about the Icom
mailing list