[ICOM] my PRO III shut down problem

[Michael Weissman, M.D.]

I had a similar problem in a Pro II a few years ago.  Solution turned 
out to be a heat sensitive crack in a circuit board (can't recall which 
one).  I had the rig repaired and traded it in on a new Pro III.  (After 
telling the store about the problem that had been fixed).

Mike,  K2CBI


On 7/2/2012 10:03 PM, hamop wrote:
>      Thanks to all for the suggestions and trouble shooting expertise ..  I feel I do have a PRO III problem causing the shut down of power output after a few seconds of transmitting. It may well be a driver problem but usually if a driver is out completely it will not ‘come back’ after turning the rig and PS off for a few minutes and then work for a few seconds when turned back on, etc.  And I do not detect any increased power output right before this happens, so do not suspect increased current draw shutting down BOTH power supplies the same way. And shutting the PRO off by itself does not always bring it back up in a few minutes, usually requires turning off BOTH the PS and PRO for several minutes to get full power again. But that only lasts about 15 seconds of CW transmitting before shutting down again. Perhaps there is a trace problem with some small leaky capacitor shorting out two circuits.
>     Anyway, thanks for the advice and suggestions. Thanks for Reflector use. Happy 4th to all Icom followers. hi
> San K5YY
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>
>