[ICOM] Icom HF Rig, 2 m rigs, and accessory items FS

Sat Mar 26 10:42:28 EDT 2011

Icom Items For Sale:

Icom IC-746 Pro, 160 thru 2 meter Multi mode transceiver:

The Icom IC-746 Pro covers 160-10 meters plus 6 and 2 meters
all mode. 100 Watts of output is available on all bands - HF,
50 MHz and 144 MHz, making the IC-746 Pro a practical choice
for all-around base station use. The die-cast aluminum chassis
and a large cooling fan help to stabilize the PA circuit,
providing 100% full duty cycle operation. The new Pro version
features 32 bit floating point DSP and 24-bit AD/DA converter.
There are NO more expensive optional filters to buy. The
digital IF filter allows one to select 51 filter bandwidths.
There are three user selectable filter memories per mode.
Soft and sharp filter shapes can be selected in both SSB and
CW modes independently. You can also change the settings on
the fly and compare! For repeater operation theres is a
built-in tone encoder and decoder with 50 CTCSS and 108
DTCS based tones. There is even a built-in Baudot RTTY
demodulator.

It has 100 alphanumeric memories, digital RF speech
compression, spectrum display, Manual and Automatic Notch,
digital Twin PBT, Noise Blanker, CTCSS encode/decode, APF,
two stage preamp, automatic antenna tuner and electronic
keyer. A built-in automatic antenna tuner operates on the
HF bands plus 6 meters. The 746 Pro requires 12 VDC at 23
amps. It is 11.3 x 4.8 x 12.5 inches in size and weighs
20 Lbs. See the May 2002 issue of QST for a review of
this radio.

Features
* Spectrum Scope
* 102 Memories
* RIT/XIT
* Digital Noise Reduction
* Manual and Automatic Notch
* Digital Twin PBT
* Dual Display
* 100 Watt Output
* 40 Watt Output (AM)
* Digital RF Speech Compressor
* Microphone Equalizer
* Monitor Transmit Audio
* SWR Plotting
* Built-in Automatic Antenna Tuner 180-6 Meters
* Full Break-In CW
* SSB/CW Synchronous Tuning
* 100% Duty Cycle
* Rx Antenna Jack
* 32 bit DSP
* 1 Hz Readout
* 4 Channel Memory Keyer
* RF Attenuator 6/12/18 dB
* RTTY Demodulator
* CW Pitch and CW Reverse
* Adjustable Transmit Bandwith
* Triple Band Stack Registers

This one works 100% as best I can tell, and looks close to
the same. I can not find a scratch on it. With paper work
for $1050.

Icom PS-125 Switching 25 amp power supply
The ICOM PS-125 switching power supply provides 13.8 VDC,
at 25 amps. The output cord has the Molex plug prewired for
many Icom radios such as the IC-746Pro, or any of
the rigs (including Kenwood and Yaesu) that require the
heavy duty 6 pin molex connector. It is 4.4 x 3.7 x 11.3
inches in size and weighs under 7 pounds. With paper
work for $135

Icom IC-22 U, 2 meter FM transceiver:

The Icom IC-22 U is a compact 2 meter FM mobile transceiver
providing selectable 10 or 1 watts of power. It features
800 channels covering 144-147.995 MHz with 5 kHz frequency
resolution. It requires 13.8 V DC at 2.8 amps.

The IC-22 U is the successor to the IC-22 S, which is the
successor to the plain IC-22 which was crystal controlled.
In the IC-22 U, the diode matrix that was used in the IC-22 S
was replaced by thumbwheel switches that permits the IC-22 U
to cover the entire 2 meter band.

For more details, please see reviews at
http://www.eham.net/reviews/detail/2652

This one includes the original microphone and power cord.
It works fine, and looks extremely nice. I would say that
it is "collectable" quality. With paper work for $85.

Icom IC-µ 2 AT (Micro 2 AT), 2 meter HT

The Icom µ 2AT is a 2 meter handheld and is an achievement
in miniaturization. The transmit range is 144-147.995 and
the receive range is 140 to 163 MHz. Output is 1.0/0.1 watts
(2.6 watts with optional power source).

The Icom µ 2AT comes with flexible BNC antenna, wrist strap,
BP-22 battery pack and BC-25U wall charger. Only 2.3 x 4.6
x 1.1 inches.

Different power levels are available by using different battery
packs. Approximate output with battery packs: BP-20 case 1.4W,
BP-21 1.2W, BP-22 1.6W, BP-23 1.6W and BP-24 2.6W.

This unit works fine and looks fine. The included BP-22 battery
pack appears to be dead, and will need a rebuild.  The HT was
tested with the DC-25 DC adapter (available separately).

With paper work and original box for $50.

Battery Chargers:

Icom BC-127 A, Battery Charger for Icom IC-Q7A Dual Band HT:
This charger charges two AA NiCads (or NiMH) for the
IC-Q7 A Dual band HT, and Icom R-2 receiver, and probably
others.
This appears to be new, unused, still in its bag.
Icom lists them at $21. Buy this one for $12.

Icom BC-110 A Wall Wort Charger:
It produces 12 V DC at 200 ma.
I am not sure of all the units that use this charger.  I know
it is used by many of the aircraft HTs, and also to charge the
R-10, T2H, T7H, T70, T80AD, T90A, T91A, T92AD, W32A, and I am
sure others.  Apparently it is also known as a BC-167 in
addition to BC-110 A.  This is NOT one of the switching units,
so you will not have RFI from this one.
This one works fine and appears very close to new.
Icom charges almost $40 for this.  Buy this one for $15.

Icom batteries and DC accessories:

Icom DC-25
This is a pack that is used on the Icom µ2AT, Icom µ4AT, and
on other HTs that use the BP-20, BP-21, BP-22, BP-23 and BP-24
battery packs.  It takes 13 V DC (such as from a cigarette
lighter), and converts it to the 9.4 V DC voltage needed for
the HT.  It is used in place of a battery.  This one works
fine and looks fine.  $20

Icom BP-21
This battery pack is DEAD and sold for rebuilding, building
a DC converter, or whatever.  $10

Icom BP-22
This battery pack is DEAD and sold for rebuilding, building
a DC converter, or whatever.  $10

Icom MB-20 Belt clip
This belt clip is used on the Icom µ 2AT series of HTs, and
probably on others as well.  This one appears to be new,
with hardware, still in its original plastic bag.  $10

ORIGINAL Icom operating manuals:

Please note that all of these are original Icom manuals
and are not copies. All are in very good condition.
These are original manuals only.

BC-30 Desk Charger $5
BC-35 Desk Charger $7
BP-2, BP-3, BP-4, BP-5 battery packs $3
BP-21, BP-22, BP-23, and BP-24 Batteries $3
DC-1 DC pack for IC-2 AT series HTs $4
HM-8 Hand Microphone, w/schematic $5
IC-22 S, 2 m FM transceiver $12
IC-3 PA Power supply / speaker $10
UT-16 Voice Synthesizer $5

These are original manuals only.

I also have many other accessories available such as
microphones, wattmeters, keyers, etc. Just too many to
list here. Many things other than Icom also!
Please e-mail your requests.

Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400