[ICOM] ICW32A BNC spanner nut tool

[Rich Dailey]

Isn't this the Amphenol 227-1490?

Rich, N8UX.

At 11:49 AM 7/26/2011, you wrote:
>Hi all,
>
>I am looking for a spanner nut tool to remove the nut on a BNC connector,
>specifically on an IC-W32A. I tried the usual things such as long needle
>nose pliers (actually broke the tip) and a couple of other tools around. The
>nut will not budge.
>
>Years ago, I had a tool set specifically for these types of nuts when I
>worked avionics repair. However, they have taken a walk into no man's land.
>These tools were basically thin wall deep sockets with two rectangular pins
>180 degrees apart. My shop is very limited and manufacturing something like
>this would take quite some time.
>
>Anyone have suggestions on a source for such a tool?
>
>Tnx,
>
>Larry
>K7YBZ
>
>
>----
>Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
>Icom Users Net: Sundays, 1700Z, 14.316 MHz
>Icom FAQ: http://www.qsl.net/icom/
>To support QSL/QTH.net: http://www.qsl.net/donate.html