[ICOM] IC-2AT PL encoder

[Gary P. Fiber]

Here you go http://www.com-spec.com/ss64.htm
They have a nice PDF that shows how to install it. You can either use or 
not use a switch if you short with jumpers the switches in the proper order.

Gary K8IZ

On 2/4/2011 8:01 AM, Dave Edwards wrote:
> My original IC-2AT had an encoder that I put in it back in the day.
> I don't remember the brand, but I think they are out of business.
> What was nice is that it was thin as a piece of cardboard, and sat in-between
> the two hinged together circuit boards.
>
> You could change tones, but the switch was a VERY small arrangement...you had to use a probe or pencil
> or something to change 'em.
>
> Is anything similar still available?   Got a new (yes, unused) 2AT....and would like to put one in it. But don't feel like
> doing the horrible square cutting through the plastic that some have been destroyed with.
>
> One tone, set and forget would be fine by me.
>
> Thanks for any input!
>
> .....Dave
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>


-- 
Gary P. Fiber K8IZ

General Radio Telephone Operators License PG-19-6691,
with Shipboard Radar Endorsement.
Washington State Resident.

Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient (s) and may contain confidential and privileged information.
Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message.