[ICOM] AFSK RTTY with PROIII

[Phil Krichbaum]

Len
    If I could get the Rig Blaster Plus to work with MMTTY and N1MM in 
FSK that would solve the problem. I do have the FSK key line out of the 
ACC connector but can't get the software to send FSK. Unfortunately I've 
not been able to solve that and was looking for a work around in the 
meantime with AFSK where I could use the RTTY filters in RX. It might be 
an scenario that could be possible but was overlooked by Icom in the 
design of the PROIII.
    Phil N0KE

Len Morris VE3FJB wrote:
> Hi Phil, just do the FSKing in the ACC 1 connector at the back as shown on 
> Sec 2 page 20 that is where I got my fixed lever AF as well.. MMTTY under 
> options set the com # you get your FSK..
> GL
> Len
> VE3FJB/VA3LM
>
> ----- Original Message ----- 
> From: "Phil Krichbaum" <vailphil at sopris.net>
> To: "Icom" <icom at mailman.qth.net>
> Sent: Wednesday, January 06, 2010 1:32 PM
> Subject: [ICOM] AFSK RTTY with PROIII
>
>
>   
>>    Maybe I missed it, but no where in the manual can I see how to use
>> the 350 Hz RTTY filter when using AFSK in LSB. Using the 1800 Hz filter
>> position plus the twin PBT it is reasonably OK down to about 900 Hz but
>> no narrower to receive RTTY effectively. Now if I could get the Rig
>> Blaster Plus to transmit FSK with N1MM and MMTY, I wouldn't have to
>> worry about this problem!
>>    Phil N0KE
>> ----
>> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
>> Icom Users Net: Sundays, 1700Z, 14.316 MHz
>> Icom FAQ: http://www.qsl.net/icom/
>> To support QSL/QTH.net: http://www.qsl.net/donate.html 
>>     
>
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>
>