[ICOM] IC 211 - where's the FM modulator to install a tone board

[Greg Mijal]

Thank you Ed
I will put her on the bench tomorrow and get it done.
Thanks again
Greg
WA7LYO
Kinston NC
----- Original Message ----- 
From: <ma.locksmith at juno.com>
To: <icom at mailman.qth.net>
Sent: Friday, November 20, 2009 4:20 PM
Subject: Re: [ICOM] IC 211 - where's the FM modulator to install a tone 
board


> Remove the top cover.  Have set front panel facing away from you.
>
> On left hand side, maybe an inch from the left edge, an inch and a half
> from the front edge of the board is R59....  FM deviation.
>
> Ed
> K1ZOK
>
> On Fri, 20 Nov 2009 15:49:32 -0500 "Greg Mijal"
> <bluebirdtele at embarqmail.com> writes:
>> Hi:
>>
>> I would like to add a tone encoder to my IC 211 2m all mode but
>> cannot locate the FM modulator.  The manual(less schematic) calls
>> out Q11 as the modulator it self but I should be looking for the
>> wiper of the transmit discriminator in order to wire in the
>> subaudible tones.
>> Any whiz kids on the IC 211 out there?
>> Thanks!
>> Greg
>> WA7LYO
>> Kinston NC
>> ----
>> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
>> Icom Users Net: Sundays, 1700Z, 14.316 MHz
>> Icom FAQ: http://www.qsl.net/icom/
>> To support QSL/QTH.net: http://www.qsl.net/donate.html
>>
>
> ____________________________________________________________
> Online Psychology Degrees
> Earn your psychology degree online. Earn your BS, MA, MBA, Ph.D now.
> http://thirdpartyoffers.juno.com/TGL2141/c?cp=iJicpKdNwcVGorDRiKtR5AAAJ1D7cSlMk8z5yUt2kS6f112HAAQAAAAFAAAAAIGVoz4AAAMlAAAAAAAAAAAAAAAAAAWSEwAAAAA=
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>