[ICOM] missing screw

[Frank A. Ellis]

Hi All,

This is apparently a fairly common problem with the 706 series and was 
recently discussed again on eHam. The screw is 2mm x 6mm long, if that 
helps you to locate a replacement.

Here is a link to the article, perhaps it will help:

http://www.eham.net/articles/21070

73, Frank KC3JH






KD7JYK DM09 wrote:
> Narrow the problem down first, put the faceplate back on the body.  If the
> problem stops, it could be a loose cable and might be related to the missing
> screw, if not, check everyhting else I
> mentioned.
>
> As for the screw, take the body into a harware store and check out SHORT
> small metric screws and see what works, it's just a screw...
>
> Kurt
>
> ----- Original Message -----
> From: "Julio Peralta" <jperalta4 at verizon.net>
>
> : Thanks for your help, but at this point we would like to find a
> replacement
> : screw for the separation cable connector. I've had experience with not
> using
> : it and it can cause problems.
>
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH: http://www.qsl.net/donate.html
>
>