[ICOM] 2725 DISPLAY

[Edward L. Dowdy]

OK :) I'll give that a try.

73,

Ed KA9EES

----- Original Message ----- 
From: "Mike - 2007" <mike-2007 at elp.rr.com>
To: "'ICOM Reflector'" <icom at mailman.qth.net>
Sent: Monday, July 16, 2007 10:20 PM
Subject: RE: [ICOM] 2725 DISPLAY


>
> I have had a problem like that in a few older IC-901As, and some FLUKE 
> DMMs
> also.
>
> The cure seems to be cleaning the LCD display contact points.
>
> The LCD display (in my case) rests on a rubber contact strip.  The rubber
> contact strip rests on the circuit board contacts.  Carefully dis-assemble
> it all, clean it with alcohol, and carefully re-assemble it all.
>
> It the rubber is stuck, DO NOT STRETCH IT by pulling on it.  Gently roll 
> it
> off sideways.
>
> THANKS TO SCOTT MALCOLM of Malcolm Technical Support (mts at trip.net) for
> suggesting the repairs and technique to me several months ago.
>
> Good luck.
>
> Mike - KD9KC.
> M.A.R.I.E.
> El Paso, Tx.
> www.w5dpd.org
>
> =============================================
> The United States Constitution (c) 1791. All Rights reserved.
> =============================================
>
>
>
>
>> -----Original Message-----
>> From: icom-bounces at mailman.qth.net
>> [mailto:icom-bounces at mailman.qth.net] On Behalf Of Bill NY9H
>> Sent: Monday, July 16, 2007 8:49 PM
>> To: ICOM Reflector
>> Subject: Re: [ICOM] 2725 DISPLAY
>>
>> when i turn on my 2725...  I have extra segments "turned on"
>> til it warms up for a while. After a few minutes all is fine
>> ....  what is that about ???
>> almost like it is cold,
>>
>> my room is about 75F....  so it happens even with room temps.
>> bill
>>
>> ----
>> Your Moderator: Dick Flanagan K7VC,
>> icom-owner at mailman.qth.net Icom Users Net: Sundays, 1700Z,
>> 14.316 MHz Icom FAQ: http://www.qsl.net/icom/
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/