[ICOM] 706mk2

[Jim Miller]

Were some of the 706 Mk II G 's built without the ut-106?
Can I tell if mine has it in without opening the radio?
Is there a published serial split?
What does it look like and where is it?
What do I see if it ISN'T installed?

73, Jim

----- Original Message ----- 
From: "D C *Mac* Macdonald" <k2gkk at hotmail.com>
To: <icom at mailman.qth.net>
Sent: Saturday, January 06, 2007 10:47 AM
Subject: Re: [ICOM] 706mk2


> I finally got around to installing the UT-106 that I
> have had almost as long as Mk II that I bought new
> before the DSP was included.
>
> I also installed the FL-232 (350 Hz CW) and FL-223
> (1.9 kHz SSB) filters.  What an improvement!!!
>
> Somewhere around here, I also have the speech unit
> to install.
>
> Mac - K2GKK
> Oklahoma City, OK
>
>
> ----Original Message Follows----
> From: Gary Fiber <gfiber at clearwire.net>
> Subject: Re: [ICOM] 706mk2
> Date: Sat, 06 Jan 2007 08:35:38 -0800
>
> The UT-106 installs into an IC-706MKII, I have one with a
> UT-106 installed.  After a while it was included as standard
> into the rig.
>
> The IC-706MKIIG had the UT-106 installed from the factory
>
> The UT-106 Will NOT install in the original IC-706 however.
>
> Gary K8IZ
>
>
> [ José=LU1ARV ] wrote:
> >Hi Hi!  For what I see in the manual, the UT-106, it is not possible to
> >install it in the IC-706MKII.   Is it correct? I don't want to open my
> >"new" rig.
> >Thank you!
> >José/73
>
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>