[ICOM] ut-102 Voice Synthesizer Unit

[Rick Robinson]

Ok Mac, here is the adjustment for the 703 if you are willing to try it. 
I don't have mine to try it on but I am reasonably sure this   is it. 
Remember to set the radio volume to your normal listening level before 
making the speech level adjustment. You will need to adjust R7205 to the 
desired level. R7205 is located on the main board. You will see the 
outline of the optional filter. It is to the left of the bottom left 
corner of the filter outline. You will see "CP 1851" silk screened on 
the board. R7205 is just to the left of this . Schematic wise it is in 
the 703 svc manual part 2, page 16, on the bottom left of the page . 
This svc man pdf  I got from www.mods.dk
I always mark the starting point of my adjustment before turning 
anything, even if I am 100 percent sure. Fine point markers work well. 
If you are willing to do this , please let me know how it worked out. If 
not then we can wait till I get mine back or someone else tries it. I 
think I found the adjustment for the 706MK2 also. It looks like the 
beep/sidetone adjustment on the side of the case will do it. Not 
positive, but  I have to  look at my paper copy as the pdf is not the 
best . I'll get back on this one. 73..Rick.

D C *Mac* Macdonald wrote:
> Okay, that answers the question I "had" about
> the UT-102 I just put into my 703.
>
> Now for another question.
>
> Is there a way to increase the volume of the
> UT-102?  At normal listening volume, I can
> barely hear the UT-102 announcements.  I
> looked all through my 703 manual and could
> not find anything on this.  This is  NOT  to
> say that it isn't there, but I didn't find it.
>
> I have another to put in my 706 Mk II, so I
> would really like to make this device really
> useful.
>
> 73 - Mac, K2GKK/5
>
>
> ----Original Message Follows----
> From: Jack - K4WSB <K4WSB at arrl.net>
> Reply-To: ICOM Reflector <icom at mailman.qth.net>
> To: ICOM Reflector <icom at mailman.qth.net>
> Subject: Re: [ICOM] ut-102 Voice Synthesizer Unit
> Date: Sat, 10 Feb 2007 05:26:13 -0500
>
> You have to press the 'lock' button
>
> At 12:32 AM 2/10/2007, you wrote:
>> How dose the ut-102 Voice Synthesizer Unit Work, I noticed when I 
>> push the mode switch it will anounce the mode, i.e. am , fm, ssb, 
>> etc... but it's supposed to anounce the freq as well how can i get 
>> this to work ???
>
> Jack Hartley
> K4WSB / VP2MSB
> ARRL - QCWA - OOTC
> DXCC Honor Roll
>
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>