[ICOM] 756pro

[Dan Cotsirilos K9DTC]

thanks Adam and everybody.



Dan K9DTC



----- Original Message ----- 
From: "Adam Farson" <farson at shaw.ca>
To: "'ICOM Reflector'" <icom at mailman.qth.net>
Sent: Monday, April 30, 2007 1:21 AM
Subject: RE: [ICOM] 756pro


> Hi Dan,
>
> You have welded the reed relay (Tyco OMR-10F) whose contacts extend a 
> ground
> on the SEND line. The relay contacts are rated at 16V/500mA non-inductive,
> and the Heathkit amplifiers use a much higher voltage.
>
> You will need to replace the relay (one hopes there was no other damage) 
> and
> install an auxiliary keying buffer.
>
> Please refer to: http://www.ab4oj.com/icom/auxrelay/main.html  or
>
> http://www.qsl.net/icom/auxrelay.html
>
> Cheers for now, 73,
> Adam VA7OJ/AB4OJ
>
>
> -----Original Message-----
> From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] 
> On
> Behalf Of Dan Cotsirilos K9DTC
> Sent: Sunday, April 29, 2007 13:03
> To: icom at mailman.qth.net
> Subject: [ICOM] 756pro
>
> I hooked up a SB-230 amp to my 756pro using the alc and send jacks. I 
> keyed
> the mic twice to test to see if was working. It worked both times but now
> the send jack on the 756pro is dead shorted???? The amp says keyed?  Does
> anybody know what happened?
>
>
> Dan K9DTC
>
>
>
>
> Scanned for viruses by Blue Coat
> http://www.WinProxy.com/
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/