[ICOM] Help, Nardo Ram unit for 271A

[Clif Holland]

Thank you, thank you, thank you. Exactly what I was looking for....

In the FWIW dept the 751 also has no jumpers. The R71 has a jumper at "0".

Clif Holland KA5IPF
www.avvid.com


----- Original Message ----- 
From: "Walter S. Szachara" <szachara at gulftel.com>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Sunday, May 21, 2006 4:33 PM
Subject: Re: [ICOM] Help, Nardo Ram unit for 271A


> Hi Clif...
>
> My Nardo Board for the IC-271 has no jumpers installed -- my Nardo Board 
> for the IC-471A has a jumper installed in the "0" pair...
>
> Hope this helps...
>
> Regards,
>
> Walt, W2OKF
>
>
> ----- Original Message ----- 
> From: "Clif Holland" <radio.service at verizon.net>
> To: "ICOM Reflector" <icom at mailman.qth.net>
> Sent: Sunday, May 21, 2006 12:09 PM
> Subject: [ICOM] Help, Nardo Ram unit for 271A
>
>
>>I have a Roberto Nardo Ram Unit for the R71A and need to jumper it for the 
>>271A. Does anyone have a 271 board they can check the jumper settings on? 
>>If you don't know about the jumpers they are on the connector side of the 
>>board. They are 3 pair of holes labelled 0, 1, & 2. I realize there are 
>>only 9 possibilities but I don't have a 271 here at the moment to try it.
>>
>> Thanks
>>
>> Roberto isn't answering e-mail.
>>
>> Clif Holland KA5IPF
>> www.avvid.com
>>
>>
>>
>> ----
>> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
>> Icom Users Net: Sundays, 1700Z, 14.316 MHz
>> Icom FAQ: http://www.qsl.net/icom/
>>
>>
>
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>