[ICOM] Icom 761 / 765 Advice needed

[Andre van Wyk]

Hi Bill,
I found some replacement buttons, thanks!
73's
Andre

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of William Lambing
Sent: Thursday, June 15, 2006 11:17 PM
To: ICOM Reflector
Subject: Re: [ICOM] Icom 761 / 765 Advice needed

If the buttons are engraved, go to a craft store and find a white grease
pencil.  Rub the pencil over the engraving to fill in the unfilled portions.
Take a white tissue paper and wipe it down.  The result is a clean readable
button.

We did this at Collins on many projects during the engineering phase and
also advised the users of the "stuff" to do this exact procedure.

When the button is wiped down, you wind up with a clean very readable button
that can be easily cleaned again by just wiping it down.

Bill, W0LPQ
----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/