[ICOM] Icom 761 / 765 Advice needed

[William Lambing]

If the buttons are engraved, go to a craft store and find a white grease pencil.  Rub the pencil over the engraving to fill in the unfilled portions.  Take a white tissue paper and wipe it down.  The result is a clean readable button.

We did this at Collins on many projects during the engineering phase and also advised the users of the "stuff" to do this exact procedure.

When the button is wiped down, you wind up with a clean very readable button that can be easily cleaned again by just wiping it down.

Bill, W0LPQ