[ICOM] Rear Panel Connector Switch : Pro2 vs Pro3

[Jerry Keller]

Thanks, Adam...
73, Jerry K3BZ
----- Original Message ----- 
From: "Adam Farson" <farson at shaw.ca>
To: "'ICOM Reflector'" <icom at mailman.qth.net>
Sent: Saturday, June 03, 2006 2:56 PM
Subject: RE: [ICOM] Rear Panel Connector Switch : Pro2 vs Pro3


> Hi Jerry,
>
> The markings on the rear panel of both radios are correct.  The 
> information
> in the Pro3 user manual (p. 11), and in the second edition of the Pro2 
> user
> manual (A-6072H-1EX-(2) p. 12) is also correct.
>
> The XVERTER and RX-ANT jacks were shown transposed in the early Pro2 user
> manual (A-6072H-1EX), p. 12.
>
> Cheers for now, 73,
> Adam VA7OJ/AB4OJ
>
>
> -----Original Message-----
> From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] 
> On
> Behalf Of Jerry Keller
> Sent: 03 June 2006 11:29
> To: (Reflector) ICOM; (Reflector) ICOM Yahoo
> Subject: [ICOM] Rear Panel Connector Switch : Pro2 vs Pro3
>
> I was just connecting my new Pro3 and noticed that all the rear panel
> connectors are in the same position except the Transverter and RX Ant RCA
> jacks are switched. Is this for real or a typo in one of the manuals?
>
> Too bad ICOM doesn't label the connectors back there.
>
> 73, Jerry K3BZ
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net Icom Users
> Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/
>
>
>
> Scanned for viruses by Blue Coat
> http://www.WinProxy.com/
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>