[ICOM] Rear Panel Connector Switch : Pro2 vs Pro3

[Adam Farson]

Hi Jerry,

The markings on the rear panel of both radios are correct.  The information
in the Pro3 user manual (p. 11), and in the second edition of the Pro2 user
manual (A-6072H-1EX-(2) p. 12) is also correct.

The XVERTER and RX-ANT jacks were shown transposed in the early Pro2 user
manual (A-6072H-1EX), p. 12.

Cheers for now, 73,
Adam VA7OJ/AB4OJ


-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Jerry Keller
Sent: 03 June 2006 11:29
To: (Reflector) ICOM; (Reflector) ICOM Yahoo
Subject: [ICOM] Rear Panel Connector Switch : Pro2 vs Pro3

I was just connecting my new Pro3 and noticed that all the rear panel
connectors are in the same position except the Transverter and RX Ant RCA
jacks are switched. Is this for real or a typo in one of the manuals? 

Too bad ICOM doesn't label the connectors back there. 

73, Jerry K3BZ
----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net Icom Users
Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/



Scanned for viruses by Blue Coat
http://www.WinProxy.com/