[ICOM] Replacement Part for Ic-2100H

[bhat srikanth]

Hi Tom,

Thank you for your reply. No, this encoder is a lot
simpler device than what you are referring to. Its a
simple switching encoder, with a mechanical switching
arrangement. The PCB i was referring to earlier was
for the switching pattern on the contact plate to
which 3 armatures make contact for requireed phase
difference, to distinguish between directions. 
One of these 3 armatures is damaged, and hence need
replaceemnt of the encoder.
I will try Icom.. 
Thanks again
73
Sri, vu2sbj



--- Tom <tmcsail at sbcglobal.net> wrote:

> I caught this post earlier, but didn't have time to
> respond. IF (and I do mean IF) this is the same
> device
> as in the IC-746pro, it is not an ordinary optical
> encoder. The one in the 746pro is a magnetic
> encoder.
> The earlier post mentioned a small PCB on the
> encoder.
> This matches the IC-746pro setup. IF this is the
> case
> - I offer this advice: look at the small board
> attached to the control. You should see two very
> small
> surface mount pots. These control the reference
> voltage to the "up-down" circuit logic.
> Using a jewler's screwdriver, make 1/16 turn
> adjustments and you might bring it back to life.
> 
> As far as getting a direct replacement, it can be
> ordered from Icom. All of their contacts can be
> found
> at:
> http://www.icomamerica.com/mailbox/
> 
> 73,
> Tom, W3TMC
> 
> 
> --- GGLL <nagato at arnet.com.ar> wrote:
> 
> > 	A friend in VU land is searching for a
> replacement
> > dial encoder part for his 
> > Icom IC-2100H transceiver. He has no luck in his
> > land,  does anybody know 
> > where can he get that part?. The part is called
> > EVQ-VENF01 in the main 
> > schematic diagram. Please send answers to bhat
> > srikanth, with e-mail address at:
> > 
> > 	bbhat at yahoo.com
> > 
> > Thank you very much.
> > 
> > Best regards
> > Guillermo - LU8EYW.
> > ----
> > Your Moderator: Dick Flanagan K7VC,
> > icom-owner at mailman.qth.net
> > Icom Users Net: Sundays, 1700Z, 14.316 MHz
> > Icom FAQ: http://www.qsl.net/icom/
> > 
> 
> ----
> Your Moderator: Dick Flanagan K7VC,
> icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com