[ICOM] Replacement Part for Ic-2100H

[Tom]

I caught this post earlier, but didn't have time to
respond. IF (and I do mean IF) this is the same device
as in the IC-746pro, it is not an ordinary optical
encoder. The one in the 746pro is a magnetic encoder.
The earlier post mentioned a small PCB on the encoder.
This matches the IC-746pro setup. IF this is the case
- I offer this advice: look at the small board
attached to the control. You should see two very small
surface mount pots. These control the reference
voltage to the "up-down" circuit logic.
Using a jewler's screwdriver, make 1/16 turn
adjustments and you might bring it back to life.

As far as getting a direct replacement, it can be
ordered from Icom. All of their contacts can be found
at:
http://www.icomamerica.com/mailbox/

73,
Tom, W3TMC


--- GGLL <nagato at arnet.com.ar> wrote:

> 	A friend in VU land is searching for a replacement
> dial encoder part for his 
> Icom IC-2100H transceiver. He has no luck in his
> land,  does anybody know 
> where can he get that part?. The part is called
> EVQ-VENF01 in the main 
> schematic diagram. Please send answers to bhat
> srikanth, with e-mail address at:
> 
> 	bbhat at yahoo.com
> 
> Thank you very much.
> 
> Best regards
> Guillermo - LU8EYW.
> ----
> Your Moderator: Dick Flanagan K7VC,
> icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>