[ICOM]PW-1 ALC

[Steve]

Adam,

I looked through the IC-PW1 links at www.qsl.net/icom/manuals.html but 
find the service manual you reference.

Would you be so kind as to point me to it?

Thanks.

Steve K8JQ

Adam Farson wrote:
> Hi Tony,
> 
> The ALC pots are R1 and R2 on the JACK-1 board. One can order them from Icom
> Parts (P/N 7310003820).
> 
> You will need the service manual to tackle repairs. The manual is
> downloadable here:
> 
> http://www.qsl.net/icom/manuals.html
> 
> In the meantime, you can use the Exciter 2 position.
> 
> Cheers for now, 73,
> Adam VA7OJ/AB4OJ
>  
> 
> -----Original Message-----
> From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
> Behalf Of Tony Visco
> Sent: 15 January 2006 15:48
> To: 'ICOM Reflector'
> Subject: RE: [ICOM]PW-1 ALC
> 
> 
> Ouch,
> 
> I was installing a new exciter and was adjusting the ALC which is a little
> difficult because of my remote location for the Linear.  Unfortunately I
> feel it is difficult to feel the adjusting screw move and of course the
> plastic adjustment made a snap sound which meant I may have pushed a little
> hard. 
> 
> It is now on a bit of an angle and of course the ALC is spiking over the
> recommended setting.
> 
> Is this a component that is accessible?? If so could I likely adjust it with
> the damaged plastic adjustment?
> 
> Is this a component that can be replaced by me?
> 
> Any helpful advice will be appreciated.
> 
> Tony W3EW
> 
> 
> 
> Scanned for viruses by Blue Coat
> http://www.WinProxy.com/
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>