[ICOM] Icom 756pro3 external video output?

[Andre VanWyk]

Thanks Adam,
Well, I guess Icom will add this feature in the radio replacing the pro3.
(Somehow I get a feeling we could see it soon....)
Andre KR5DX

Adam Farson <farson at shaw.ca> wrote: Sorry to disappoint you, but the LCD control and drive interfaces in the
Pro3 are non-standard and very complex. A look at the service manual will
confirm this. 

Also, Icom do not publish the protocols for the interfaces between the main
bus, the LCD Controller (IC3551, MAIN-A Board) and the LCD Interface
(IC1401, Display Board).

Cheers for now, 73,
Adam VA7OJ/AB4OJ
 

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Andre van Wyk
Sent: 27 December 2006 14:06
To: 'ICOM Reflector'
Subject: [ICOM] Icom 756pro3 external video output?

I was wondering if anyone out there tried to get a video signal out of the
Icom 756pro3 for an external display?
73's KR5DX -.-





Scanned for viruses by Blue Coat
http://www.WinProxy.com/
----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/