[ICOM] ICOM 746 PRO circa 2004

[D C *Mac* Macdonald]

Make sure you have set the SQ/RF Gain to operate
in the manner you wish.  Look in the manual for
help on this.  I believe you can set the control to
work  ONLY  as RF Gain, SQ, or a combo of both
for various modes.

Mac - K2GKK/5



----Original Message Follows----
From: "Ken Woodside, WB8EQO" <wb8eqo at yahoo.com>
Reply-To: ICOM Reflector <icom at mailman.qth.net>
To: icom at mailman.qth.net
Subject: [ICOM] ICOM 746 PRO circa 2004
Date: Fri, 11 Aug 2006 08:14:57 -0700 (PDT)

My 746 PRO is doing something funny and I can't figure
out what I messed with in the controls to make this
occur.

After I transmit on SSB PTT, or CW on break-in mode,
the receiver sensitivity remains low for 5 to 10
seconds after transmitting until I can once again hear
my contact. Like I have inadvertantly entered some
kind of delay on the re-start of the receiver.

Any help would be most appreciated!

Does anyone else find the ICOM instructions to be
completely non-instructive???

Tnx,

Ken
WB8EQO

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/