[ICOM] IC-2KL on 240v

[David J. Ring, Jr.]

Larry,

Take off the strap, then with a Ohm meter test the two sections of the 
primary (which are in parallel when used on 120vac) - you might have one of 
the windings open - which will reduce your power output on 120vac, and give 
you ZERO voltage when using 240vac (the two sections are in series then).

73

David N1EA

----- Original Message ----- 
From: "Larry Clark" <k0rs at augwest.com>
To: <icom at mailman.qth.net>
Sent: Thursday, September 22, 2005 9:47 PM
Subject: [ICOM] IC-2KL on 240v


Is anyone using an IC-2KL on 240v?  I changed the transformer strapping in
mine to the configuration in the manual, plugged it in and....nothing.
(Yes, I double checked the strap position and my outlet wiring).  No pilot
lights, nada.  Switched it back to 120v and it works fine, except now I have
no pilot lamp on the PS.  What's up?  TIA.

Larry,  K0RS


----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/