[ICOM] FL52A problem-additional details

[John Geiger]

Hi Gary,

It has pin sockets and is supposed to be a drop in filter.

73s John NE0p

----- Original Message -----
From: <gfiber at comcast.net>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Friday, September 16, 2005 10:07 PM
Subject: Re: [ICOM] FL52A problem-additional details


> John,
>
> Sometimes the filter case will short out the signal. Try lifting the
filter a little or
> put a  piece of electrical tape across the pins making sure the pins of
the filter push through the tape. Now see if the signal comes back.
> Does the circuit board have the pin sockets or just holes? I forget if the
original IC-756 required you to actually solder in the filter or not.
>
> Gary K8IZ
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>